Free air post shipping over $100, excluding some oversized items

GM6208-150T Gimbal Motor w/ Encoder


The GM62 series motor by iPower Motors is the ultimate brushless gimbal motor for DSLR / CANON 5D MARKII, MARKIII Cameras. This motor is designed for large scale multi-rotor platforms looking to lift Red Epic & DSLR sized gear – 4KG/cm Torque. The principle of the camera stabilization using brushless direct-drive motors, In fact, gimbal based on BLDC motors is very similar to regular gimbal based on hobby servo.


Model: GM6208

Motor Out Diameter: Ф69.5±0.05mm

Configuration: 24N/28P

Motor Height: 32±0.2mm (Included with Encoder housing)

Hollow Shaft(OD): Ф25-0.01/-0.015 mm

Hollow Shaft(ID): Ф22+0.05/+0 mm

Wire Length: 610±3mm

Cable AWG: #24

Motor Weight: 265±0.5g

Wire plug: 2.5mm dupont connector

No-load current: 0.08±0.1 A

No-load volts: 20 V

No-load Rpm: 209~231 RPM

Load current: 1.2A

Load volts: 20V

Load torque(g·cm): 2600-3600

Motor internal resistance: 32Ω±5%(Resistance varies with temperature)

High voltage test: DC500V 1mA @2sec

Rotor housing runout: ≤0.1mm

Steering (axle extension): clockwise

High-low temperature test:

High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Maximum power: ≤25W

Working current: 3-5S

Working temperature: -20~60℃;10~90%RH

Packing List

1 x GM6208 150T Brushless Gimbal Motor

1 x  AS5048A Encoder with aluminum case

Write a review

Please login or register to review
  • ����ͼƬ·��
$1 IFPV PointsIFPV Points