GM110-10 Gimbal Motor

The principle of the camera stabilization using brushless direct-drive motors, In fact, gimbal based on BLDC motors is very similar to regular gimbal based on hobby servo.

Special designed for SLR aerial and Z axis DIY Parts

Sealed Case to prevent contamination by dust and dirt.

Hollow shaft for slipring

Configuration: 36N42P ,prove more torque.

Model: GM110-10

Motor Out Diameter: Ф110±0.05mm

Configuration: 36N/42P

Motor Height: 26±0.2mm (Included with Encoder housing)

Hollow Shaft(OD): Ф25-0.008/-0.012 mm

Hollow Shaft(ID): Ф22+0.05/+0.1 mm

Wire Length: 610±3mm

Cable AWG: #24

Motor Weight: 532±1g

Wire plug: 2.5mm dupont connector

No-load current: 0.16±0.1 A

No-load volts: 20 V

No-load Rpm: 292~323 RPM

Load current: 2 A

Load volts: 20 V

Load torque(g·cm): 9000-15000

Motor internal resistance: 4.16Ω±5%（Resistance varies with temperature）

High voltage test: DC500V 1mA @2sec

Rotor housing runout: ≤0.1mm

Steering (axle extension): clockwise

High-low temperature test:

High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Maximum power: ≤80W

Working current: 4-6S

Working temperature: -20~60℃;10~90%RH

1 x GM110-10 brushless gimbal motor