GM5208-12 Combo Set

The controller can be used for building high-quality 3-axis camera stabilizing systems which can be mounted to UAV and for building handheld camera stabilizers.

This version of the controller is our new direction in the development of the stabilizing solutions. It will replace the previous 8-bit version of the SimpleBGC controller, keeping 100% back-compatibility, but adding the new functionality.

iPower Motor GM5208-12 Brushless Gimbal Motor

The GM52 series motor by iPower Motors is the ultimate brushless gimbal motor for DSLR / CANON 5D MARKII, MARKIII Cameras.

This motor is designed for large-scale multi-rotor platforms looking to lift Red Epic & DSLR sized gear – 4KG/cm Torque.

The principle of the camera stabilization using brushless direct drive motors, In fact, gimbal based on BLDC motors is very similar to regular gimbal based on hobby servo.

Model: GM5208

Motor Out Diameter: Ф63±0.05mm

Configuration: 12N/14P

Motor Height: 22.7±0.2mm 

Hollow Shaft(OD): Ф15-0.008/-0.012 mm

Hollow Shaft(ID): Ф12+0.05/0 mm

Wire Length: 610±3mm

Cable AWG: #24

Motor Weight: 195±0.5g

Wire plug: 2.5mm dupont connector

No-load current: 0.09±0.1 A

No-load volts: 20V

No-load Rpm: 456~504 RPM

Load current: 1A

Load volts: 20V

Load torque(g): 1800-2500

Motor internal resistance: 15.2Ω±5%（Resistance varies with temperature）

High voltage test: DC500V 10mA @1sec

Rotor housing runout: ≤0.1mm

Steering (axle extension): clockwise

High-low temperature test:

High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Maximum power: ≤40W

Working Voltage: 3-5S

Working temperature: -20~60℃;10~90%RH

3 x GM5208-12 Gimbal Motor

1 x Alexmos 32BIT BGC set without alum case

1 x Connecting cables set