GM110-8 Gimbal Motor w/ Encoder

The principle of the camera stabilization using brushless direct drive motors, In fact, gimbal based on BLDC motors is very similar to regular gimbal based on hobby servo.

Sealed Case to prevent contamination by dust and dirt.

Hollow shaft for slipring

Configuration:24N28P,provide more torque.

Model: GM110-8

Motor Out Diameter: Ф110±0.05mm

Configuration: 24N/28P

Motor Height: 33.9±0.2mm (Included with Encoder housing)

Hollow Shaft(OD): N/A

Hollow Shaft(ID): N/A

Wire Length: 610±3mm

Cable AWG: #24

Motor Weight: 610±3g

Wire plug: 2.5mm dupont connector

No-load current: 0.09±0.1 A

No-load volts: 20V

No-load Rpm: 125~139 RPM

Load current: 2A

Load volts: 20V

Load torque(g·cm): 8000-12000

Motor internal resistance: 20.19Ω±5%（Resistance varies with temperature）

High voltage test: DC500V 1mA @2sec

Rotor housing runout: ≤0.1mm

Steering (axle extension): clockwise

High-low temperature test:

High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Maximum power: ≤60W

Working current: 4-6S

Working temperature: -20~60℃;10~90%RH

1 x iPower GM110-8 Gimbal Motor

1 x  AS5048A Encoder with aluminum case