iflight.com

Free air post shipping over $100, excluding some oversized items

GM8112-80T Encoder Combo Set

AVAILABILITY: In Stock
$679.99

Available Options

Description

Encoders are special sensors that are added to each brushless motor of a Gimbal Stabilizer allowing the system to more accurately track motor position for increased stability which in turn also increases battery efficiency.

What's encoder technology in brushless gimbal control system?

The 3 axis stabilization gimbal system that relies on both active motor-driven components and passive inertial stabilization. Passive stabilization relies on the principles of inertia (a tendency of an object to resist change in its motion) and requires that the camera is well-balanced in the Pan, Tilt, and Roll Axes. Active stabilization refers to the techniques of using sensors to measure the camera’s Pan, Tilt, and Roll movements and counteract those movements using motors attached to the 3 axes.

Features

Easy to do gimbal tuning, no need to do much calibration work anymore.

Power saving, 5 times long working time than gimbal without encoder system.

Twin IMUs.

Faster response, motor torque increasing instantly, no bug for difficult rotating angle anymore.

Encoder chip A5048a

Specifications

Model: GM8112

Motor Out Diameter: Ф89.5±0.05mm

Configuration: 36N/42P

Motor Height: 33.4±0.2mm (Included with Encoder housing)

Hollow Shaft(OD): Ф25-0.008/-0.012 mm

Hollow Shaft(ID): Ф22+0.05/+0.1 mm

Wire Length: 610±3mm

Cable AWG: #24

Motor Weight: 446±1g

Wire plug: 2.5mm dupont connector

No-load current: 0.3±0.1 A

No-load volts: 22V

No-load Rpm: 380~420 RPM

Load current: 2A

Load volts: 20V

Load torque(g): 6000-9000

Motor internal resistance: 4.2Ω±5%(Resistance varies with temperature)

High voltage test: DC500V 1mA @2sec

Rotor housing runout: ≤0.1mm

Steering (axle extension): clockwise

High-low temperature test:

High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature

Maximum power: ≤80W

Working current: 3-5S

Working temperature: -20~60℃;10~90%RH

Packing List

3 x GM8112 Gimbal Motor with AS5048A Encoder & Magnet

1 x Alexmos 32BIT BGC Board Encoder version without alum case

1 x Connecting cables set

Write a review

Please login or register to review
  • ����ͼƬ·��
$1 IFPV PointsIFPV Points