Borg Mini F7 Flight Controller - w/Rx
Introducing the All-New Borg Series – Power Meets Precision!
The Borg Mini F7 Flight Controller (With Receiver) is custom-built for racing FPV and delivers exceptional performance. This advanced controller comes with a built-in ELRS 2.4GHz receiver and integrated antenna. It delivers a stable signal connection and smoother flight control during use.
Beyond its internal receiver, the Borg Mini F7 Flight Controller (With Receiver) also supports external receivers. This lets you tailor your device setup to fit your unique racing requirements. Upgrade your FPV racing experience with the state-of-the-art Borg Series!
Built-in ELRS 2.4GHz Receiver, while also being compatible with external antennas for enhanced flexibility.
Supports 4S to 8S battery inputs, offering versatility for various racing setups.
Integrated 12V BEC provides stable power for your VTX system and allows remote control to switch it on and off.
FPC cables ensure secure connections with ESCs, while SH1.0 connectors enhance reliability across all other interfaces.
Flight Controller Specifications
Input voltage: 4-8S; Support LIHV battery
MCU: STM32F722RET6
Gyro: ICM42688
OSD Chip: AT7456E（LGA）
Flash: 16MB (Blackbox flash)
UARTS: 6
Motor outputs: 4
I2C serial: Support
VTX protocol: support DJI MSP/Smartaudio/IRCTramp/HDZero
LED controller: Yes
Beeper pad: Yes
Betaflight Firmware target: IFLIGHT_BLITZ_F722
Mount pattern: 20*20 φ4
Dimensions: 34*28.5mm±1
Weight: 6.8g±1
BEC: 5V 2.5A, 12V 2A (12V with VTX switch)
SMD Receiver Specifications
MCU: ESP8285
RF: SX1281
Receiver Type: 2.4GHz
Telemetry power: 17mW (12.3dBm)
LNA: No
Lua Script: iFlight 2.4GHz Nano
TCXO: Yes
Firmware: iFlight 2.4GHz Nano RX
UART 1 for VTX HD / Analog
UART 2 for On-board Receiver
UART 3 for GPS or other sensors that require a serial port
UART 4 for GPS or other sensors that require a serial port
UART 5 for GPS or other sensors that require a serial port
UART 6 for ESC Telemet
1 x Borg Mini F7 Flight Controller With SMD Receiver
1 x Cable set
5 x silicon grommets
resource PINIO 1 C0
set pinio_config = 1,1,1,1
set pinio_box = 40,41,255,255
set box_user_1_name = VTX_ON_OFF
aux 0 40 8 900 2100 0 0
save
