The GM8112 motor by iPower Motors is the ultimate brushless gimbal motor for Red Epic / Large Cameras. This motor
is designed for large scale multi-rotor platforms looking to lift Red Epic & DSLR sized gear – 6KG/cm Torque. The
principle of the camera stabilization using brushless direct drive motors, In fact, gimbal based on BLDC motors is very
similar to regular gimbal based on hobby servo.
Model: GM8112
Motor Out Diameter: Ф89.5±0.05mm
Configuration: 36N/42P
Motor Height: 26±0.2mm (Included with Encoder housing)
Hollow Shaft(OD): Ф25-0.008/-0.012 mm
Hollow Shaft(ID): Ф22+0.05/+0.1 mm
Wire Length: 610±3mm
Cable AWG: #24
Motor Weight: 428±1g
Wire plug: 2.5mm dupont connector
No-load current: 0.3±0.1 A
No-load volts: 22V
No-load Rpm: 380~420 RPM
Load current: 2A
Load volts: 20V
Load torque(g·cm): 6000-9000
Motor internal resistance: 4.2Ω±5%（Resistance varies with temperature）
High voltage test: DC500V 1mA @2sec
Rotor housing runout: ≤0.1mm
Steering (axle extension): clockwise
High-low temperature test:
High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
Maximum power: ≤80W
Working current: 3-5S
Working temperature: -20~60℃;10~90%RH
1 x GM8112 Gimbal Motor
