The principle of the camera stabilization using brushless direct-drive motors, In fact, gimbal based on BLDC motors is very similar to regular gimbal based on hobby servo.
Special designed for SLR aerial and Z axis DIY Parts
Sealed Case to prevent contamination by dust and dirt.
Hollow shaft for slipring
Configuration: 36N42P ,prove more torque.
Model: GM110-10
Motor Out Diameter: Ф110±0.05mm
Configuration: 36N/42P
Motor Height: 26±0.2mm (Included with Encoder housing)
Hollow Shaft(OD): Ф25-0.008/-0.012 mm
Hollow Shaft(ID): Ф22+0.05/+0.1 mm
Wire Length: 610±3mm
Cable AWG: #24
Motor Weight: 532±1g
Wire plug: 2.5mm dupont connector
No-load current: 0.16±0.1 A
No-load volts: 20 V
No-load Rpm: 292~323 RPM
Load current: 2 A
Load volts: 20 V
Load torque(g·cm): 9000-15000
Motor internal resistance: 4.16Ω±5%（Resistance varies with temperature）
High voltage test: DC500V 1mA @2sec
Rotor housing runout: ≤0.1mm
Steering (axle extension): clockwise
High-low temperature test:
High temperature: Keep at 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
Low temperature: Keep at -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature
Maximum power: ≤80W
Working current: 4-6S
Working temperature: -20~60℃;10~90%RH
1 x GM110-10 brushless gimbal motor
Ask Question About Product
Related Products
